天堂岛精品🔇_830888.com_.手.动.输.入.网.址.联.系.客.服.人.员.lanan_shell
(R) 0 TEST button Activates IO-second maximum internal test of the RFCI. On successful completion of the test, the LCDs show the test display. If the TEST button is held for more than 10 seconds the display will automatically return to the display prior to test. Figure 19-7. Radio Frequency/ChanneIln dicator (Sheet 1 of 2) 19-11 ORIGINAL NAVAIR 0%F14AAD-1 “n.reUP, cn,mE I FUNCTION ,.“,.,~m.Y~m”m.- . _.__.. -._ @ VOL control Enable RIO to adjust level of audio signal. Clockwise rotation increases audio level. 0 XMTR SEL buttons Enables RIO to select desired radio for voice communications (V/UHF or JTIDS). Note When JTIDS voice communications is selected V/UHF plain voice communications are inhibited. If V/UHF encrypted voice communication is selected, both V/UHF (encrypted) and JTIDS will transmit simultaneously. Figure 19-7. Radio Frequency/ChanneIln dicator (Sheet 2 of 2) 19.3.4 Have Quick Load instructions. Have Quick antijam voice communications entry uses preset chatinel40. The contentso f presetc hannel4 0 designatesth e loadingm odei n which thennit is operatingT. he following loading codes are used tc operate and load in Have Quick II: 1. 220.000 - Qperate in Have Quick II. 2. 220.025 - MWOD load mode. 3. 220.050 - MWOD erase mode. 4. 220.075 - FMT load mode. If the aircrew desiis to enter Have Quick without loading or verifying, 220.000 should be loaded into preset channel 40 using the procedures in paragraph 19.3.4.13.o therwise, Have Quick I processingi s used. 19.3.4.1 Net Selection. Have Quick I and II use the same method of net selection. A net is a six-digit number that selects the frequency table that will be hopped on. Net numbers are in the form of AXXXYY, where A indicates a Have Quick net, X is a number Tom 0 to 9 deftig the net, and W is either 00,25,50, or 75, which determines the combat or training operational mode. The operational modes am 1. COMBAT a. 00 - Qperate in Have Quick I. b. 25 - Have Quick II NATO. c. 50 - Have Quick II Non-NATO. d. 75 - Not Used. 2. TRAINING a. 00 - HaveQuickITmining. b. 25 - Have Quick II Training. c. 50/75 - Not Used. The 1,000 combat nets range t?om 000 to 999. The variables in these net numbers refer the radio to specific frequencies and algorithms within the radio’s memory. There are five Have Quick I tmining nets displayed as AOO.XOOw, here X is 0 to 4. There are 16 Have Quick II training nets displayed as AOXX25, where X.X is 0.0 to 1.5. The variables in these training net numbers tell the radio the training thequencyo n which to begin hopping. Training nets are activated by a special WOD (300.0X39 in segment one of the WOD used for that dsy. The last two digits determine the hop rate. The same applies tc the last two digits of the fmt segment of combat WODs. 19.3.4.2 Word of Day/Multiple Word of Day. A WODiMWOD is a transmission security variable. Have Quick I radios use a WOD consisting of six segments of six digits each. Have Quick II radios use a MWOD that adds a seventh segment containing a two-digit date tag and live more MWODs for 6 days of operation without reloading WODs. The WODMWOD is loaded into the radio to key the Have Quick system tc the proper hopping pattern, dwell time, and hop rate. The hop rate is included in the fast segment of each WODMWOD. XXXXYY, where YY is 00,25,50,75, denoting slow to fast hop rates. When operating with Have Quick I systems, only one ofthe six MWODs is used. See Figure 19-10. ORIGINAL 19-12 NAVAIR 01.F14AAD-1 JTIDS 7 NOMENCIATURE FUNCTION 3 JTIDS SEL switch Selects JTIDS 1 or 2 voice channel for pilot’s voice transmissions. Both channels are always selected to receive. 3 JTIDS-1, JTIDS-2, V/UHF-2 volume Clockwise rotation increases audio level of received transmission (Pilot only). control Figure 19-8. Pilot VOLUME Control Panel 19-13 ORIGINAL NAVAIR 01.Fl4AAD-1 TEST 680.000 TEST 465 TEST 061 TEST 651 TEST 157 TEST 333 FAULT INTERPRETATION RMT or RT SELECT TEST MODE LOW PWR SELECT TEST MODE RMT CTRL DEFECTIVE CONTROL NONE RT AND CTRL OK RT MODULES 4,5, OR 6 SAD VSWR RT OR ANTENNA SYSTEM FWDPWR RT OR ANTENNA SYSTEM I RT MODULES 1,5, OR 7 I RT MODULE 3 SAD I Figure 19-9. Common BIT Indications 1 .l 269.950 2.1 295.850 3.1 290.450 4.1 275.950 5.1 270.450 6.1 300.050 1.2 299.000 2.2 289.600 3.2 279.000 4.2 269.300 5.2 259.000 6.2 249.000 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：F-14D 飞行手册 Flight Manual 3
