国内精品♨️_国产精品一品二区三区麻豆绿夜_.手.动.输.入.网.址.联.系.客.服.人.员.lanan_shell
1EFF : ALL 1 27-84-45Page 459 1 1 Feb 01/00R 1 1 1CES 1
INTENTIONALLY BLANK
27-84-45Page 460 1 1 Feb 01/00 1 1 1CES 1 TASK 27-84-45-000-007
Removal of the Torque Shafts 6016CM(6066CM)/6020CM(6070CM)/6026CM(6076CM)/ 6030CM(6080CM) WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU _______ START A TASK ON OR NEAR: - THE FLIGHT CONTROLS
- THE FLIGHT CONTROL SURFACES
- THE LANDING GEAR AND THE RELATED DOORS
3. Job Set-up __________ (Ref. Fig. 401/TASK 27-84-45-991-001) Subtask 27-84-45-941-055 A. Safety Precautions (1) Put the safety barriers in position.
(2) Put a warning notice in position to tell persons not to operate the slat controls.
Subtask 27-84-45-860-070 B. Aircraft Maintenance Configuration (1) Retract the slats fully (Ref. TASK 27-80-00-866-005).
Subtask 27-84-45-865-055 C. Open, safety and tag this(these) circuit breaker(s): -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1 5CV B06 121VU FLIGHT CONTROLS/SLT/CTL/SYS2 7CV R21 Subtask 27-84-45-010-055 D. Get Access (1) Put the adjustable access platform in position below the applicable access panel.
(2) Remove the applicable access panel:
- FOR 6016CM remove 521EB
- FOR 6020CM remove 521EB
- FOR 6026CM remove 522AB
1EFF : ALL 1 27-84-45Page 462 1 1 May 01/98R 1 1 1CES 1
remove 522CB - FOR 6066CM remove 621EB
- FOR 6070CM remove 621EB
- FOR 6076CM remove 622AB
- FOR 6080CM remove 622CB.
(2) Remove the nuts (10), the bolts (11) and then the shaft (9).
(3) Remove the universal joint (8).
1EFF : ALL 1 27-84-45Page 463 1 1 May 01/98R 1 1 1CES 1
TASK 27-84-45-400-008 Installation of the Torque Shafts 6016CM(6066CM)/6020CM(6070CM)/6026CM (6076CM)/6030CM(6080CM)
WARNING : MAKE SURE THAT THE FLIGHT CONTROL SAFETY-LOCKS AND THE WARNING _______ NOTICES ARE IN POSITION.
WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING _______ GEAR.
1. Reason for the Job __________________ www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：A320飞机维护手册 AMM FLIGHT CONTROLS 飞行操纵8
